A Rhino management sub task for configuring a queue saturation limiter.

Ant Parameters
Attribute Description Required

failonerror

Flag to control failure behaviour. If 'true', the sub task will throw a BuildException when an error is encountered. If 'false', the sub task will throw a NonFatalBuildException instead of a BuildException under specific circumstances. See below for conditions (if any) which will cause a NonFatalBuildException.

No. default value is taken from the Rhino management parent task.

name

The name of the queue saturation limiter to be configured.

Yes.

maxsaturation

The maximum amount of saturation allowed in the staging queue before rejecting work, expressed as a percentage. A value of '-' may be used to clear existing per-node settings when a list of nodes is specified.

No.

bypassed

Whether this limiter will be used or bypassed for limiting. If false the limiter will be used (not bypassed), if true the limiter will be bypassed and hence not be used. A value of '-' may be used to clear existing per-node settings when a list of nodes is specified.

No.

parent

Sets the parent of the limiter, adding the limiter to its parent’s limiter hierarchy.

No.

nodes

Comma-delimited list of nodes to apply this configuration to. Only the maxsaturation and bypassed configuration properties may be set on a per-node basis, all other properties are set uniformly across all nodes.

No.

Previous page Next page
Rhino Version 3.2