Rhino 2.6.2 :: Rhino Administration and Deployment Guide :: Configuring Authentication Details

To configure authentication details for accessing Rhino’s SNMP subsystem, use the following rhino-console commands.

`setsnmpcommunity`

Command	setsnmpcommunity <community> Description Sets the SNMP community.
Example

Command

setsnmpcommunity <community>
  Description
    Sets the SNMP community.

Example

`setsnmpuserdetails`

Command	setsnmpuserdetails <username> <authenticationProtocol> <authenticationKey> <privacyProtocol> <privacyKey> Description Sets the SNMP v3 user and authentication details.
Example

Command

setsnmpuserdetails <username> <authenticationProtocol> <authenticationKey>
<privacyProtocol> <privacyKey>
  Description
    Sets the SNMP v3 user and authentication details.

Example

`setsnmpuserengineid`

Command

setsnmpuserengineid <hex string>
  Description
    Sets the user configurable portion of the SNMP LocalEngineID.

This only sets a user-configurable portion of the engine ID — not the entire engine ID. The SNMP agent calculates full engine ID from the OpenCloud enterprise OID, the node ID, and the user-configurable string.

You need to change the user-configurable string only if the SNMP agent needs to distinguish between different clusters on the same network.

Example

`getsnmpuserengineid`

Command	getsnmpuserengineid Description Returns the user configurable portion of the SNMP LocalEngineID.
Example

Command

getsnmpuserengineid
  Description
    Returns the user configurable portion of the SNMP LocalEngineID.

Example

`listsnmpengineids`

Command

listsnmpengineids
  Description
    Lists the SNMP EngineIDs for each node.

Each node returns a different but similar engine ID.

Example

`enablesnmpversion`

Command	enablesnmpversion <v1\|v2c\|v3> Description Enables support for the specified SNMP protocol version.
Example

Command

enablesnmpversion <v1|v2c|v3>
  Description
    Enables support for the specified SNMP protocol version.

Example

`disablesnmpversion`

Command	disablesnmpversion <v1\|v2c\|v3> Description Disables support for the specified SNMP protocol version.
Example

Command

disablesnmpversion <v1|v2c|v3>
  Description
    Disables support for the specified SNMP protocol version.

Example

Previous page Next page