A Rhino management sub task for configuring a relative stat limiter.
| Attribute | Description | Required |
|---|---|---|
failonerror |
Flag to control failure behaviour.
If 'true', the sub task will throw a |
No. default value is taken from the Rhino management parent task. |
name |
The name of the rate limiter to be configured. |
Yes. |
parameterset |
The parameter set for the statistic to monitor. If setting this, statistic must also be specified. |
No. |
statistic |
The statistic to monitor. If setting this, parameterset must also be specified. |
No. |
relativeparameterset |
The parameter set for the statistic to compare against. If setting this, relativestatistic must also be specified. |
No. |
relativestatistic |
The statistic to compare against. If setting this, relativeparameterset must also be specified. |
No. |
bypassed |
Whether this rate limiter will be used or bypassed for limiting rate.
If |
No. |
parent |
Sets the parent of the limiter, adding the limiter to its parent’s limiter hierarchy. |
No. |
relativepercentages |
Comma-delimited list of rate limit tiers as relative percentages of relative stat value. Values must be between 0 and 100 inclusive. Must specify the same number of values in limitpercentages corresponding to the percentage of calls to limit in each relative percentage tier. |
No. |
limitpercentages |
Comma-delimited list of rate limit percentages per relative percentage. Values must be between 0 and 100 inclusive. A value of '-' may be used to clear (remove) the corresponding relative percentage tier. Must contain the same number of values as specified in relativepercentages. |
No. |
nodes |
Comma-delimited list of nodes to apply this configuration to. Only the relativepercentages, limitpercentages, and bypassed configuration properties may be set on a per-node basis, all other properties are set uniformly across all nodes. |
No. |
