A Rhino management sub task for configuring an absolute stat limiter.
| Attribute | Description | Required |
|---|---|---|
failonerror |
Flag to control failure behaviour.
If 'true', the sub task will throw a |
No. default value is taken from the Rhino management parent task. |
name |
The name of the rate limiter to be configured. |
Yes. |
parameterset |
The parameter set for the statistic to monitor. If setting this, statistic must also be specified. |
No. |
statistic |
The statistic to monitor. If setting this, parameterset must also be specified. |
No. |
bypassed |
Whether this rate limiter will be used or bypassed for limiting rate.
If |
No. |
parent |
Sets the parent of the limiter, adding the limiter to its parent’s limiter hierarchy. |
No. |
values |
Comma-delimited list of rate limit tiers as values of the monitored statistic at which each tier should begin to take effect. Must specify the same number of values in limitpercentages corresponding to the percentage of calls to limit in each value tier. |
No. |
limitpercentages |
Comma-delimited list of rate limit percentages per value. Values must be between 0 and 100 inclusive. A value of '-' may be used to clear (remove) the corresponding value tier. Must contain the same number of values as specified in values. |
No. |
nodes |
Comma-delimited list of nodes to apply this configuration to. Only the values, limitpercentages, and bypassed configuration properties may be set on a per-node basis, all other properties are set uniformly across all nodes. |
No. |
