To enable or disable usage notifications, use the following rhino-console command or related MBean operation.

Note
The notifications-enabled flag

To enable notifications to output usage parameters to management clients, set the usage notifications-enabled flag, and an appropriate debug level for the SLEE component’s relevant tracer. To disable notifications, unset the notifications-enabled flag.

Console command: setusagenotificationsenabled

Command

 
setusagenotificationsenabled <type> <notif-source> <name> <flag>
    Set the usage notifications-enabled flag for specified usage notification
    source's usage parameter

Example

 
$ ./rhino-console setusagenotificationsenabled sbb \
    "service=ServiceID[name=VPN Service,vendor=OpenCloud,version=0.2],sbb=SbbID[name=VPN SBB,vendor=OpenCloud,version=0.2]" \
    callAttempts true
Usage notifications for usage parameter callAttempts for
SbbNotification[service=ServiceID[name=VPN Service,vendor=OpenCloud,version=0.2],sbb=SbbID[name=VPN SBB,vendor=OpenCloud,version=0.2]]
have been enabled

MBean operation: set<usage-parameter-name>NotificationsEnabled

MBean

SLEE-defined

 
public void set<usage-parameter-name>NotificationsEnabled(boolean enabled)
    throws ManagementException;

Arguments

  • enabled — a flag to enable or disable notifications for this usage parameter.

Notes
Enabling usage notification

Usage notifications are enabled or disabled on a per-usage-parameter basis for each notification source. That means that if usage notifications are enabled for a particular usage parameter, if that usage parameter is updated in any usage parameter set belonging to the notification source, a usage notification will be generated by the SLEE.
Previous page Next page
Rhino Version 2.5.0