This section applies in the case where the Rhino VoLTE TAS SGC has previously received its initial configuration and now requires reconfiguration.
![]() |
If only the SGC’s SNMP subsystem requires reconfiguration it is recommended to follow the procedure at Reconfiguring the SGC’s SNMP Subsystem as that process does not cause a full SGC outage. |
Reconfiguration of the SGC requires a SMO or an SGC VM with version 4.0.0-9-1.0.0 or newer. Reconfiguration of the SGC component in older VMs is not supported.
![]() |
Reconfiguring the SGC will cause a full SS7 outage in live deployments. |
There are two stages to reconfiguring the SGC:
Even if you have reconfigured the SGC before it is essential that you follow both of these steps.