To inspect a rate limiter’s ramp-up configuration, use the following rhino-console command or related MBean operation.

Console command: getrampupconfiguration

Command

 
getrampupconfiguration [limitername]
  Description
    Retrieves the limiter rampup configuration settings, if it is enabled. If no
    limiter is specified the settings of the SystemInput limiter are shown.

Example

To inspect the SystemInput limiter’s ramp-up configuration:

$ ./rhino-console getrampupconfiguration
Rampup of the SystemInput limiter is active with the following config properties:
startrate=10.0 events per time unit
rateincrement=10.0 events per time unit
eventsperincrement=100

To inspect the ramp-up configuration of the "From MSC" rate limiter:

$ ./rhino-console getrampupconfiguration "From MSC"
Rampup of the From MSC limiter is active with the following config properties:
startrate=5.0% of maximum rate
rateincrement=5.0% of maximum rate
eventsperincrement=800

LimiterRampUp MBean operations

Operation

Usage

isEnabled

 
boolean isEnabled()
        throws ConfigurationException;

getStartRate

 
double getStartRate()
        throws ConfigurationException;

getRateIncrement

 
double getRateIncrement()
        throws ConfigurationException;

getEventsPerIncrement

 
int getEventsPerIncrement()
        throws ConfigurationException;
Previous page Next page
Rhino Version 3.0.0