Rhino versions prior to 3.0.0 had two modes of operation for managing the activation state of services and resource adaptor entities: per-node and symmetric. From Rhino 3.0.0 these two modes were combined and have been superseded by default desired state which can be overridden by per-node desired state. Per-node desired state overrides default desired state if present. Default desired state is effective if no per-node desired state exists. The commands and Ant tasks to enable and disable symmetric activation state mode remain but do not prevent later modification of per-node desired state.
A Rhino management sub task for enabling symmetric activation state mode.
Rhino versions prior to 3.0.0 had two modes of operation for managing the activation state of services and resource adaptor entities: per-node and symmetric. From Rhino 3.0.0 these two modes were combined and have been superseded by default desired state which can be overridden by per-node desired state. Per-node desired state overrides default desired state if present. Default desired state is effective if no per-node desired state exists. The commands and Ant tasks to enable and disable symmetric activation state mode remain but do not prevent later modification of per-node desired state.
| Attribute | Description | Required |
|---|---|---|
templatenode |
The ID of the node to base symmetric state one. May be the string value 'any' to allow any node to be selected. |
Yes. |
failonerror |
Flag to control failure behaviour.
If 'true', the sub task will throw a |
No. default value is taken from the Rhino management parent task. |
-
The task is run when the symmetric activation state mode is already enabled.
@Deprecated(since = "3.0.0")
