configureabsolutestatlimiter

failonerror

Flag to control failure behaviour. If 'true', the sub task will throw a BuildException when an error is encountered. If 'false', the sub task will throw a NonFatalBuildException instead of a BuildException under specific circumstances. See below for conditions (if any) which will cause a NonFatalBuildException.

No. default value is taken from the Rhino management parent task.

name

The name of the rate limiter to be configured.

Yes.

parameterset

The parameter set for the statistic to monitor. If setting this, statistic must also be specified.

No.

statistic

The statistic to monitor. If setting this, parameterset must also be specified.

No.

bypassed

Whether this rate limiter will be used or bypassed for limiting rate. If false the limiter will be used (not bypassed), if true the limiter will be bypassed and hence not be used. A value of '-' may be used to clear existing per-node settings when a list of nodes is specified.

No.

parent

Sets the parent of the limiter, adding the limiter to its parent’s limiter hierarchy.

No.

values

Comma-delimited list of rate limit tiers as values of the monitored statistic at which each tier should begin to take effect. Must specify the same number of values in limitpercentages corresponding to the percentage of calls to limit in each value tier.

No.

limitpercentages

Comma-delimited list of rate limit percentages per value. Values must be between 0 and 100 inclusive. A value of '-' may be used to clear (remove) the corresponding value tier. Must contain the same number of values as specified in values.

No.

nodes

Comma-delimited list of nodes to apply this configuration to. Only the values, limitpercentages, and bypassed configuration properties may be set on a per-node basis, all other properties are set uniformly across all nodes.

No.