VNF validation tests

What are VNF validation tests?

The VNF validation tests can be used to run some basic checks on deployed VMs to ensure they have been deployed correctly. Tests include:

  • checking that the management IP can be reached

  • checking that the management gateway can be reached

  • checking that sudo works on the VM

  • checking that the VM has converged to its configuration.

Running the VNF validation tests

After deploying the VMs for a given VM type, and performing the configuration for those VMs, you can run the VNF validation tests for those VMs from the SIMPL VM.

Run the validation tests: csar validate --vnf sgc --sdf <path to SDF>

If any of the tests fail, refer to the troubleshooting section.

Note An MDM CSAR must be unpacked on the SIMPL VM before running the csar validate command. Run csar list on the SIMPL VM to verify whether an MDM CSAR is already installed.

OCSS7 SGC Checks

Verify that the OCSS7 SGC is running

Connect to the OCSS7 SGC using the SGC CLI (command line interface). The SGC CLI executable is located at ~/ocss7/<deployment_id>/<node_id>/current/cli/sgc-cli.sh.

Use the display-info-nodeversioninfo command to show the live nodes. There should be one entry for each SMO node in the cluster.

Alarms

Check using the SGC CLI that there are no active SGC alarms. Use the display-active-alarm command to show the active alarms. There should be no active alarms on a correctly configured cluster with live network connectivity to the configured M3UA peers.

See the OCSS7 Installation and Administration Guide for a full description of the alarms that can be raised by the OCSS7 SGC.

Previous page Next page
VM Build Container Version 3.2