Rhino Checks

Note

Sentinel IP-SM-GW can be disabled in smo-vmpool-config.yaml. If Sentinel IP-SM-GW has been disabled, Rhino will not be running.

Alarms

Check using MetaView Server or REM on the MAG node that there are no active Rhino alarms. Refer to the Troubleshooting pages if any alarms are active.

Active components

Check using REM on the MAG node that various SMO components are active.

Check REM Page Expected Result

Check SLEE is running

Monitoring tab → Cluster Nodes → State

The SLEE should be in the Running state.

Check Sentinel IP-SM-GW SLEE services are active

Monitoring tab → Services

sentinel.ipsmgw, sentinel.registrar should be active.

Check Sentinel IP-SM-GW Resource Adaptors are active

Monitoring tab → Resource Adaptor Entities

  • cassandra-ipsmgw, cassandra-ipsmgw-registrar, cassandra-third-party-reg, cdr, cginmapra, diameter-sentinel-internal, ipsmgw-correlation-ra, sentinel-management, sh-cache-microservice-ra, sip-sis-ra, sipra and uid should be active.

  • diameterro-0 should be active if any of the charging options are enabled.

OCSS7 SGC Checks

Verify that the OCSS7 SGC is running

Connect to the OCSS7 SGC using the SGC CLI (command line interface). The SGC CLI executable is located at ~/ocss7/<deployment_id>/<node_id>/current/cli/sgc-cli.sh.

Use the display-info-nodeversioninfo command to show the live nodes. There should be one entry for each SMO node in the cluster.

Alarms

Check using the SGC CLI that there are no active SGC alarms. Use the display-active-alarm command to show the active alarms. There should be no active alarms on a correctly configured cluster with live network connectivity to the configured M3UA peers.

See the OCSS7 Installation and Administration Guide for a full description of the alarms that can be raised by the OCSS7 SGC.

Previous page Next page
Rhino VoLTE TAS VMs Version 4.2