About this task
This task creates the node flavor(s) that you will need when installing your deployment on OpenStack virtual machines.
|
You must complete this procedure before you begin the installation of the first node on OpenStack, but will not need to carry it out again for subsequent node installations. |
Create your node flavor(s)
Detailed procedure
Repeat the following procedure for every node type, i.e. TSN, ShCM, MAG, MMT CDMA, and SMO.
-
Run the following command to create the OpenStack flavor, replacing
<flavor name>with a name that will help you identify the flavor in future.nova flavor-create <flavor name> auto <ram_mb> <disk_gb> <vcpu_count>where:
-
<ram_mb>is the amount of RAM, in megabytes -
<disk_gb>is the amount of hard disk space, in gigabytes -
<vpu_count>is the number of virtual CPUs.Specify the parameters as pure numbers without units.
-
You can find the possible flavors in the Flavors section, and it is recommended to use the same flavor name as described there.
Some node types share flavors. If the same flavor is to be used for multiple node types, only create it once.
-
Make note of the flavor ID value provided in the command output because you will need it when installing your OpenStack deployment.
-
To check that the flavor you have just created has the correct values, run the command:
nova flavor-list -
If you need to remove an incorrectly-configured flavor (replacing <flavor name> with the name of the flavor), run the command:
nova flavor-delete <flavor name>
Again, make sure to repeat this procedure for every node type, i.e. TSN, ShCM, MAG, MMT CDMA, and SMO.
