SAS integration

The Rhino VoLTE TAS supports Metaswitch’s SAS (Service Assurance Service) integration.

What you need

  • ❏ To chose whether or not to activate SAS tracing.

  • ❏ The IP addresses or DNS hostnames of SAS servers to connect the Rhino VoLTE TAS to.

Setting up the SAS interface

The configuration for the SAS to Rhino VoLTE TAS interface is in the sas-config.yaml file.

In the sas section, configure the servers list. The example configuration given here indicates input for what is needed for integrating the Rhino VoLTE TAS with SAS servers in a network.

sas-config.yaml
sas:

  # Whether SAS is enabled ('true') or disabled ('false')
  enabled: true

  # Parameters for connecting to SAS
  sas-connection:
    # List of SAS servers. Either IP addresess or DNS hostnames.
    # Needs to be specified in a non-MDM deployment.
    servers:
      - 10.10.10.10
      - 10.10.10.11
      - sas.example.com

SNMP integration

The Rhino VoLTE TAS supports integration with SNMP based systems.

What you need

  • ❏ The version of SNMP to be used.

  • ❏ If using SNMP v2c, the SNMP community value.

  • ❏ The SNMP agent details such as location and contact address.

  • ❏ If using SNMP notifications, each notification target’s host, port, and specifc SNMP version.

Setting up the SNMP interface

The configuration for the SNMP to Rhino VoLTE TAS interface is in the snmp-config.yaml file.

In the snmp section, configure the targets list. The example configuration given here indicates input for what is needed for integrating the Rhino VoLTE TAS with SNMP services in the network.

snmp-config.yaml
snmp:

  # Enable SNMP v1 (not recommended)
  v1-enabled: false

  # Enable SNMP v2c
  v2c-enabled: true

  # Enable SNMP v3
  v3-enabled: false

  # SNMP Community. Required for SNMP v2c
  community: clearwater

  # SNMP agent details
  agent-details:
    location: Unknown location
    contact: support.contact@invalid.com

  # SNMP Notifications
  notifications:

    # Enable SNMP Notifications
    enabled: true

    # SNMP notification targets. Normally this is the address of your MVS
    targets:
      - version: v2c
        host: 127.0.0.1
        port: 162
Previous page Next page
Rhino VoLTE TAS Version 4.2