Planning for the procedure

Background knowledge

This procedure assumes that:

  • you are installing into an existing VMware vSphere deployment which has pre-configured networks and VLANs; this procedure does not cover setting up a VMware vSphere deployment from scratch

  • you know the IP networking information (IP address, subnet mask in CIDR notation, and default gateway) for the nodes.

  • you have read the installation guidelines at Installation and upgrades overview and have everything you need to carry out the installation.

Reserve maintenance period

This procedure does not require a maintenance period. However, if you are integrating into a live network, we recommend that you implement measures to mitigate any unforeseen events.

Plan for service impact

This procedure does not impact service.

People

Anyone can perform these MOP steps.

Tools and access

This page references an external document: SIMPL VM Documentation. Ensure you have a copy available before proceeding.

Installation Questions

Question More information

Do you have the correct CSARs?

All virtual appliances use the naming convention - <node type>-<full-version>-vmware-csar.zip. Here, <node type> can be sgc. For example, sgc-1.0.0-vmware-csar.zip where 1.0.0 is the software version. In particular, ensure you have the VMware vSphere CSAR.

Do you have a list of the IP addresses that you intend to give to each node of each node type?

Each node requires an IP address for each interface. You can find a list of the VM’s interfaces on the Network Interfaces page.

Do you have DNS and NTP Server information?

It is expected that the deployed nodes will integrate with the IMS Core NTP and DNS servers.

Method of procedure

Step 1 - Extract the CSAR

This can either be done on your local Linux machine or on a SIMPL VM.

Option A - Running on a local machine

Note If you plan to do all operations from your local Linux machine instead of SIMPL, Docker must be installed to run the rvtconfig tool in a later step.

To extract the CSAR, run the command: unzip <path to CSAR> -d <new directory to extract CSAR to>

Option B - Running on an existing SIMPL VM

For this step, the SIMPL VM does not need to be running on the VMware vSphere where the deployment takes place. It is sufficient to use a SIMPL VM on a lab system to prepare for a production deployment.

Transfer the CSAR onto the SIMPL VM and run csar unpack <path to CSAR>, where <path to CSAR> is the full path to the transferred CSAR.

This will unpack the CSAR to ~/.local/share/csar/.

Step 2 - Write the SDF

The Solution Definition File (SDF) contains all the information required to set up your cluster. It is therefore crucial to ensure all information in the SDF is correct before beginning the deployment. One SDF should be written per deployment.

It is recommended that the SDF is written before starting the deployment. The SDF must be named sdf-rvt.yaml.

See Writing an SDF for more detailed information.

Important

Each deployment needs a unique deployment-id. Avoid re-use of deployment IDs between different systems. For example, a lab deployment should have a different deployment ID to a production deployment.

Example SDFs are included in every CSAR and can also be found at Example SDFs. We recommend that you start from a template SDF and edit it as desired instead of writing an SDF from scratch.

Previous page Next page
Rhino VoLTE TAS VMs Version 4.0.0