# This file is optional. If you do not use any custom routing rules,
# you can omit this file from the configuration bundle uploaded to CDS.

deployment-config:routing:
  routing-rules: []

# To create routing rules, populate the routing-rules list as shown in the example below.
#  routing-rules:
#    - name: Example
#
##     The target for the routing rule.
##     Can be either an IP address or a block of addresses (e.g. 10.0.0.0/8).
#      target: 8.8.8.8
#
##     The interface to use.
##     Can be one of 'management', 'diameter', 'ss7', 'sip', 'internal', 'access', 'cluster',
##     'diameter-multihoming' or 'ss7_multihoming'.
#      interface: management
#
##     The IP address of the gateway to route through.
#      gateway: 0.0.0.0
#
#      The node types this routing rule applies to.
#      If ommitted, this routing rule will be attempt to apply itself to all node types.
#      node-types:
#      - tsn
#      - mag
#
#    - name: Example2
##     ...
Previous page Next page
Rhino VoLTE TAS VMs Version 4.1