REM not running after installation
Check that bootstrap and configuration were successful:
[sentinel@rem1 ~]$ grep 'Bootstrap complete' ~/bootstrap/bootstrap.log 2019-10-28 13:53:54,226 INFO bootstrap.main Bootstrap complete [sentinel@rem1 ~]$
If the bootstrap.log does not contain that string, examine the log for any exceptions or errors.
[sentinel@rem1 ~]$ report-initconf status status=vm_converged [sentinel@rem1 ~]$
If the status is different, examine the output from report-initconf for any problems.
If that is not sufficient, examine the ~/initconf/initconf.log file for any exceptions or errors.
Further information can be found from the REM logs in /var/log/tas.
In particular, the REM logs are found in /var/log/tas/apache-tomcat.
tag::rem[] == Cannot connect to REM
Connect to REM using a web browser. The connection should be over HTTPS to port 8443 of the
management interface, and to the /rem/ page. For example: https://192.168.10.10:8443/rem/
If you connect using a hostname rather than the IP address, be sure that the hostname refers only to a single server in DNS.
If connections to REM fail despite use of the correct hostname/IP and port, try the following:
-
Check the REM service status on the node you are trying to connect to with
sudo systemctl status rhino-element-manager. It should be listed asactive (running). -
Check that
jpslists aBootstrapprocess (this is the Apache Tomcat process). -
Check that
netstat -ant6shows two listening sockets, one on the loopback address127.0.0.1, port 8005, and the other on the management address, port 8443:tcp6 0 0 127.0.0.1:8005 :::* LISTEN tcp6 0 0 192.168.10.10:8443 :::* LISTEN
If any of the above checks fail, try restarting REM with sudo systemctl restart rhino-element-manager.
You can also check for errors in the log files in the /var/log/tas/apache-tomcat directory.
Cannot log in to REM
When connecting to REM, you should use one of the accounts set up in the rem-vmpool-config.yaml file. The default username/password documented in the REM product documentation is not available on the REM node.
When trying to connect to Rhino, REM asks for credentials
When trying to connect to a Rhino instance, you need to enter the credentials REM can use to connect to Rhino. The Rhino username and password are configured in the VM pool YAML file for the Rhino nodes being monitored.
The mapping from REM users to Rhino users is deployment-specific (for example, you may wish to allocate a separate Rhino user to each REM user, so it is clear in Rhino audit logs which user made a certain change to Rhino configuration). As such, the VM software is unable to set up these credentials automatically.
It is recommended to use the "Save credentials" option so that you only need to specify the Rhino credentials once (per user, per instance).
Known REM product issues
For known REM issues, refer to the Known issues in REM section in the REM documentation. end::rem[]
