The Record Timestamps feature records the times at which Sentinel received a call’s initial request, and its associated final response.
Details
Name in feature scripts |
RecordTimestamps |
|---|---|
Applicable contexts |
SIP service |
SAS Support |
No |
Prerequisite features |
N/A |
Feature execution points |
SipAccess_SessionStart, SipAccess_PartyResponse, SipThirdPartyAccess_SessionStart |
Timer usage |
N/A |
Source Code
This feature’s source code is available in the Sentinel SDK in the sentinel-sip-service-information-modules module pack.
It can be viewed by using the create-module command in the SDK with that module pack. This command will prompt you for
information needed to create the new modules, once completed the original source for the feature can be found in the new modules.
The module-pack includes the following modules relevant to this feature:
| Module Name | Description |
|---|---|
sentinel-sip-service-information-modules |
Group module for all service information features, including the modules listed below. |
sentinel-sip-service-information-session-state-library |
Contains the session state interface for the feature. |
sentinel-sip-record-timestamps-feature |
Contains the feature itself. |
Session state inputs and outputs
Outputs
| Name | Type | Format | Description |
|---|---|---|---|
PerLegInitialRequestTimeMillis |
Map<String,Long> |
A table mapping each leg to the difference, measured in milliseconds, between the current time and midnight, January 1, 1970 UTC. |
Time that the initial request was received on each leg |
PerLegFinalResponseTimeMillis |
Map<String,Long> |
A table mapping each leg to the difference, measured in milliseconds, between the current time and midnight, January 1, 1970 UTC. |
Time that the final response to the initial request was received on each leg |
Statistics
| Name | Description |
|---|---|
RequestTimestampSet |
Counter incremented when the timestamp for the initial request is set. |
ResponseTimestampSet |
Counter incremented when the timestamp for the final response is set. |
Behaviour
The feature needs to be run in two separate modes at different phases of each execution point. The inbound mode should be invoked in the SIP system pre scripts
to process the incoming trigger leg. In inbound mode, it verifies that it was triggered by an initial request, or the final response to
such a request. If neither of these conditions is met, the feature will finish execution without modifying any state.
In outbound mode, it checks outgoing messages on all SIP legs.
If it detects an initial request, the feature will record the current system time into
the PerLegInitialRequestTimeMillis session state field against the corresponding leg name, increment the associated statistic, and then finish execution. If it
detects a final response, the feature will record the current system time into the
FinalResponseTimeMillis session state field and increment the associated statistic.
